Nearly all of the time, companies would spend lots of money to purchase their lift trucks. It is important, therefore to take proper care of your equipment to protect your investment into the long run. It is a great idea to know the procedures that are carried out during the care and maintenance of this piece of equipment.
Among the best ways to tell how good the engine is running is by starting the lift truck up and listening carefully to see how it works. For example, if there are any misses or knocks, the machine is defective and this must raise some concerns. In addition listen closely for any squealing sounds which come from the belts since these noises will provide you with a wealth of information.
Several of the main parts requiring attention during maintenance comprise the safety warning devices, gauges, horn, the overhead guard and the lights. Any faulty components or burnt out light bulbs should be replaced as soon as they are noticed. It is also essential to inspect the wiring.
When the above components have been inspected carefully, proceed to the battery compartment to be able to see if the terminals are clean. If the terminals are not clean, be sure to clean them properly. Each and every cell of the battery needs to be inspected so as to ensure the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the machine and after that change the filters. The fuel filters, hydraulic filter and the transmission filter have to be replaced on a regular basis. Before fitting them, be sure to write the date on the new filters by utilizing a permanent marker to be able to keep track.
After the oil change is done and the filters have been replaced, a visual inspection of the drive axle has to be performed. If there is a grease fitting on the axle make sure to apply some grease. Check the engine belts for any frays or cracks. If you find any, fix the problem accordingly. Then, inspect each and every other component of the machine including the wheels. If any kind of fault or problem is detected, be certain to deal with it immediately so as to make sure the equipment is running at its safest and optimum levels.